DISCOVERY 3 & 4 LIGHT BAR MOUNT

€240.00

Part Number: 224578

PRODUCT DESCRIPTION:

This is ProSpeed's standard light bar mount, it cannot be fitted alongside the Land Rover raised air intake however it is compatible with the Safari snorkel.

Tubular protection light mounting bar for the Land Rover Discovery 3 and 4.
Mounts into existing holes on the A-pillar under the plastic trim. Two holes require enlarging by approx. 1mm.
Adjustable tilt angle.
Optimum mounting position just above the top of the windscreen
Designed to fit Lazer Lamps (road legal solution) but has a number of pre-drilled holes to work with any light setup.
Mounted as close to the roof line ass possible for reduced wind noise.
It doesn’t increase the height of the vehicle above the standard or extended roof rails.
Compatible with or without the ProSpeed roof rack.

WIRING LOOM:

Plug and play – direct into the standard Land Rover lighting stalk plug. No splicing looms, no scotch locks. No tools required.
Shaped to exactly fit the Discovery 3 and 4.
Routed so there’s no need to drill any holes or cut out any plastic or panels.
Fits LHD and RHD vehicles.
100% waterproof.
Abrasion resistant covering where required.
Thin ribbon loom down a-pillar to prevent the trim popping off.
Takes power direct from the battery.

AUXILIARY CONTROL MODE:

Entirely solid state – no relays nor moving parts to wear out or go wrong.
Self resetting fuses – all the protection with none of the hassle. If there’s a problem, the fuses will blow to protect the circuit. But when the problem is fixed the circuit will re-connect automatically.
100% waterproof.
Compatible with LED, HID and normal lamps.
Switching is compatible with normal 12v vehicle systems and also CN bus systems including diagnostic circuits and power-saving circuits. This massively simplifies wiring in a modern vehicle where CAN bus systems have both power saving and diagnostic pulses which make it impossible to wire auxiliary lamps to them.
Completely isolated from the CAN bus circuits , meaning no damage or faults can occur in expensive body control modules of modern cars.
Runs 4x roof lamps on two circuits , 2x bumper lamps and DRLs, 4x work lamps on two separate circuits.
Switching for forward facing lamps is – Off, On with main beam, On permanently

Specific ProSpeed accessories, Here!

DIFFERENT SET UPS:

ProSpeed light bar mount only – 240€
ProSpeed light bar mount with two Lazer ST-8 or Triple-R 1000 LED spotlights (includes wiring loom and control module) – 1750€
ProSpeed light bar mount with four Lazer ST-4 or Triple-R 750 LED Spotlights (includes wiring loom and control module) – 1950€
ProSpeed light bar mount with two Lazer ST-8 or Triple-R 1000 and two Lazer ST-4 or Triple-R 750 LED Spotlights (includes wiring loom and control module) – 2300€

Every set-up we offer is road legal using Lazer’s E11 approved driving beams. Please state which lights you’d like when ordering.